The Viper NT originate from the continued development and improvement of the Viper fog machine. It unites the current digital technology with the proven technique and power of its predecessor. New features guarantee a much more simple operation – place and fog, reducing the amount of time needed to set up the machine.
 
Features
The control panel with LED-display, simple symbols allow for easy operation. It also protects the control buttons against dirt.
Digital technology makes fine adjustment of the pump possible. In steps of 1% the output can be adjusted from 0 – 99%. Thus, any desired effect from a tiny fog-cloud to the thickest fog can be produced. This enables the Viper NT to be used in both small and large locations.
The Viper NT can be controlled via DMX 512. The connection is done with 5pin-XLR-plugs.
The DMX start address can be adjusted and saved via the control panel.
The machine can also be controlled with analog (0 – 10 V) via a lighting desk or via XLR-remote (option). This connection is done with 3pin-XLR- plugs.
A stand-alone-mode is also possible. The adjustments are done directly at the machine. A short press at the start button makes the machine run. Therefore a permanent pressing of the start button is unnecessary.
With the internal timer the fog time can be exactly adjusted in seconds, the wait time in minutes and the output in percentage.
Safety
The change of the design is not only cosmetic, it also has improved safety features.
The Viper NT is equipped with new safety features. On the front and the back part of the cover there are fixing points for safety bonds.
At both sides of the bottom of the machine are three wholes to which a hanging yoke complete with a collecting tray for fluid drips can be fixed.
Fluid
The following Look-fog fluids are available for the Viper NT:
Quick-Fog (thick, quick disappearing fluid)
Regular-Fog (thick, long lasting fluid)
Slow-Fog (thick, extremly long lasting fluid)